• Introducing The Internal UPS

  • The UPS That Fits in Your Computer

Smart Internal Series UPS
SI-400/401/402/425

Internal UPS

SI series is the industries first and only uninterruptible power supply system (UPS) with the ability to be mounted into a PC case using a 5 1/4" drive bay. A fully integrated UPS with all the necessary components of a traditional UPS in a single box. Providing convenient, space saving, hassle free, and power protection solution to mission-critical computing environments.

Special Feature

  • Microprocessor based design.
  • Adjustable Rated voltage, Voltage-transfer points, Green mode, Low battery shut-down level, & Over level, etc.
  • Smart battery management with intelligent double stages of charging control & Thermal compensation.
  • Real time auto-detection for battery condition.
  • Automatic restart of load after UPS shutdown.
  • Generator compatible.
  • "Green Power" design with auto on/off function & adjustable level.
  • Standard DB-9 port with optional RS-232 & USB for communication, compatible with all major O.S., including Windows, Linux, SCO UNIX, & DOS.
  • Protection for overload, short circuit, & over heat.
  • Suitable for 5 1/4" disk size.
  • Easy installation.
  • Hardware Review by: Rob Hughes (05/04/2000) Click here to read the review.

Additional Information
INSTALLATION OVERVIEW

    PRECAUTION:
  • This UPS is suitable only for personal computer or workstation use, and is to be installed inside a computer case.
  • When installing, please make sure the maximum power requirement is not over the rated capacity of the UPS. The Red LED will be lighted and an alarm will beep if the load is close to the rated value. Meanwhile, if a blackout occurs and the overload is severe the UPS will shut down immediately to protect itself.
  • Please charge for at least 12 hours before the first use.

    INSTALLATION:
  • Fix the metallic window plate on the rear panel of your computer case.
  • Plug the connector of the enclosed "Y" type power cord into the window plate.
  • Plug the connector of the power cord from the UPS with the matching connector of "Y" power cord.
  • Connect "Y" power cord with the inlet of your computer, and the original power cord of your computer respectively.
  • Click here for an animated illustration.

    TEST STEPS:
  • Please have the UPS charged for 12 hours before test. (There is no need to turn your computer on, just to keep the city power connected to the computer.)
  • With normal mode of UPS, turn on your computer, push the UPS button on the front panel for self-test. If it is OK, green LED will be on. While if it is over loaded, the UPS will alarm. Or if the battery level is low, it will have quick beeping for several seconds and stay in normal mode for recharging.
  • Push the button for 4-5 second. To check if the UPS can be turned-off manually.
  • Push the button again to turn on the UPS, then UPS will enter standby status, and finish the test.
  • IF ANY ABNORMAL CONDITION OCCURS, PLEASE PUSH THE BUTTON FOR AT LEAST 5 SECONDS TO SHUT DOWN THE UPS; THEN WAIT FOR 3 SECONDS AND RE-PUSH THE BUTTON TO RESTART THE UPS.

Specification Sheet

To obtain this product's specification sheet, please click here.
Adobe reader is required to view these catalogue, click here to download it.

Contact Beam Tech

4F, No. 756 Chung-Cheng Rd., Chung-Ho (23586), New Taipei, Taiwan
TEL: 886-2-2226-1000
FAX: 886-2-2225-6675